Passover napkin ring

One more great project from Rachel. Rachel, thank you again for the great project!

Rachel created this project using Passover set designs.

Instructions

• Use software such as Embird to reduce the design size to 4”x4”

  
  

   

• Hoop felt fabric, or hoop tear away stabilizer and place a large enough piece of felt on top
  
  

• Stitch design up to the end of the inner border, stop the machine
  
  



• Place a piece of matching cotton fabric in the back, stitch out the outer border, Cut out carefully all around about ¼” from the outer border



 

• Cut out carefully all around about ¼” from the outer border
  



 

• Mark the center in the back, cut out a ribbon about 15” long, fold ribbon in half, place fold on the marked center and glue the ribbon to the back of the napkin ring about an inch  on both sides of the fold

• Fold the napkin as you wish, tie in the back

Place on the plates for your Seder or Passover table